| Sr.No. | Gypsum Plaster | Cement Plaster |
| 1 | Whereas gypsum plaster can only be used on interior rooms it cannot be used in wet areas like toilet bath kitchen wash area balconies etc. | Cement plaster can be used for plastering both the external walls and the internal walls and ceilings of the building. |
| 2 | Gypsum plaster does not shrink as it undergoes very little expansion and contraction. So there are fewer Shrinkage cracks in gypsum plaster as compared to traditional cement plaster. | Cement plaster has the tendency to shrink, which results in hairline cracks on the plastered surface. |
| 3 | Gypsum plaster is highly resistant to mould and mildew. | Cement plaster is prone to attacks by mould or mildew. |
| 4 | Gypsum plaster doesn’t need any curing saving water and time during construction. | The cement-plastered surface needs curing with water for at least 7 days. Do note that improperly cured walls develop cracks. |
| 5 | Gypsum plaster isn't resistant to moisture. | Cement plaster is resistant to moisture. |
| 6 | Gypsum plaster, gypsum is used as a binding material instead of cement. Gypsum plaster It is ready to use and does not need sand. | Cement plaster is a homogeneous mixture of Portland cement and sand with water. Sand and cement are mixed at the site in different ratios. |
| 7 | Gypsum plaster is generally 11 mm thick for walls and 8 mm thick for ceiling and finish coat plaster is 2 mm thick. | The thickness of the cement plaster should not be less than 10 mm. For example, for brick walls thickness of plaster is 12 mm to 20 mm. For the interior of the RCC ceiling/ roof, thickness of the plaster is generally 10 to 12 mm. |
| 8 | Gypsum plaster has low thermal conductivity and good thermal properties and ensures energy and power saving. | It has less same thermal conductivity as Gypsum plaster. |
| 9 | Gypsum plaster can prevent shrinkage because it has high tensile and flexural strength. | Cement plaster can develop shrinkage because it has Low tensile hand fractural and strength. |
| 10 | Gypsum is non-combustible and contains a high content of crystal water. In the event of a fire, it acts as a barrier and will protect. | Cement plaster up to 200 to 300 C acts as refractory material and resists fire but later it becomes brittle and breaks and falls and loses bond with the wall. |
| 11 | Gypsum as a binder is used in the manufacture of acoustic tiles and plasters, a contributory factor to the absorption of airborne sounds. | Cement plaster has more or less same acoustics properties. |
| 12 | Due to the nature and structure of gypsum, it exhibits excellent bonding properties hence is applied in a single coat on RCC ceilings, internal bare-brick walls, AAC blocks, and concrete columns. | Cement plaster cannot be applied on the smooth surface. |
| 13 | The setting time of gypsum plaster can be controlled. The time between two successive coats is very small. | The minimum 24-hour interval between coats of interior Portland cement plaster. After a 48-hour period finish coat plaster may be applied to the interior cement base coat. |
| 14 | The percentage of wastage is nominal during application. | The percentage of wastage is higher during application. |
| 15 | The application of gypsum plaster is a time-saving process, thus decreases the project cost. Gypsum plaster is costlier than cement plaster for the same thickness. | The application of cement plaster is a time-consuming process hence increases the project cost. However, per square feet cost of cement plaster is less than gypsum plaster due to the higher cost of gypsum. |
| 16 | After sand cement plaster, POP punning is required for the better and level surface finish. The space looks small and unattractive as it is dark grey in colour. | Gypsum plaster provides a smooth interior finish for ceiling, walls and is an ideal back-ground for good quality paints and wallpaper finishes. The room space looks large and beautiful as gypsum plaster is pure white in colour. |
| 17 | Gypsum plaster keeping is not required we can directly apply the paint. | In the case of cement plaster, we need pop punning on the plastered surface to receive paint. |
| 18 | Whereas is gypsum plaster is a green building product. | Whereas is gypsum plaster is a green building product. |
| 19 | Gypsum plaster is a time-saving process thus decreases the project cost. | Cement plaster is a time-consuming process, hence increases the project cost. |
| 20 | The density of gypsum plaster is less as compared to cement plaster gypsum plaster is light in weight. | The density of cement plaster is higher than gypsum plaster, hence the load on the building increases. |
| 21 | Gypsum plaster is the perfect rust preventive agent and also inhibits corrosion of electric metal, fitting. Pipes etc. | Cement plaster is not a rust inhibitor. |
Please share by clicking this button!
Visit our site and see all other available articles!